Dear reader, if you are after detailed instructions on how to successfully propagate Gracilis bamboo from cuttings, this is the link you are after: How to successfully propagate Gracilis bamboo from cuttings as I have managed to grow new Gracilis from cuttings after numerous trials. The instructions in this page were not that good and the rate of success was none.

I have finally managed to successfully propagate my very own Bambusa Textilis var. Gracilis! I obtained some culms from a friend and I now have some leaves that have started to bud and very tiny root systems.

It is only fair that I share my findings, but I have to give a lot of credit to Shawn Gilbert who was absolutely instrumental in providing the key points to a successful propagation.

I have currently got a 40% success rate – but this was my first attempt using Shawn’s technique and I have to confirm it works! I am still a little unsure about the exact science as this bamboo has proven to be a difficult plant to propagate. I should also say I didn’t use root hormone (I was too busy cutting the bamboo like mad)

Here are the important points to note:

• When you first cut the culms, put them in a bucket full of some type of richgrow liquid formula. I used “Seasol” diluted in water and soaked the culms for 2 to 3 hours (it is a seaweed fertiliser rich in nitrogen – grass loves nitrogen)
• You must use old culms, the older the better
• Try to find culms with a diameter larger than 1″
• I found culms with large buttons at the nodes had a better success rate than nodes with no buttons (this is for the 2 node cuttings)
• Water the culms every day (ensure that you fill the culm with water) for the first month and a half
• Pick the right time… I planted my culms in the middle of May (Southern Hemisphere = winter)

I have searched the internet for bamboo propagation via culm cuttings and identified two types of cuts that can be used. One cut has 2 nodes, and the other cut only has 1 node and all of the branches coming out of the node have been cut back – all except for the main one (as per Shawn’s website).
It took 2 weeks for the first leaves to appear, but at the 1 month mark, tiny branches were popping out of the buttons at the nodes .

I also noticed the culms that stayed green after the 1.5 month mark would be successful as they had leaves pop out soon after.

We are now getting to the 2 month mark and I pulled one of the culms out to see if it had roots. The photos below show a thin, long and stringy roots.

I am going to leave the culms in the pots a couple of months longer and wait for spring to swing by.

Update: 19th May 2016 – these cuttings all dried and died after months of watering.

But this page: How to successfully propagate Gracilis bamboo from cuttings has instructions that actually worked!